| |
FREQUENTLY ASKED QUESTIONS
The projection from
my computer is broken up into three sections and it says "YCbCr No Signal."
- This problem can be corrected very easily but it requires the
use of the Remote Control. Open the Flip Cover of the Remote Control
and press the "Menu" button so that the Advanced Menu is projected.
Using the Cursor Key (see user Manual) of the remote, high light the
Color Menu. Use the Cursor Key to then highlight Source Change. "YCbCr"
will be high lighted in RED. High light "RGB" and then press the ENTER
button located on the under side of the remote. The projector should
re-acquire the RGB signal and the projection should return to normal.
Return to the beginning of Frequently Asked Questions.
|
|
|
